Manuals Available :
|
|
Owner’s Manual – English :
|
|
Owner’s Manual – Spanish :
|
Quick Reference Sheet :
Arming
Away Mode – used when everyone is leaving the house. Arms perimeter and interior devices
- Enter 4 digit code + [AWAY] and exit house
Stay Mode – used when someone is staying in the house. Arms perimeter but not motion detectors
- Enter 4 digit code + [STAY]
Disarming
- Enter the 4 digit code + [OFF] when entering the house or if the system is in alarm.
Panic Buttons
- Hold the panic button down 3 to 5 seconds to activate
- If your keypad does not have the panic buttons along the left, press * + # together to activate panic
Changing Codes
Change Master Code
- Press 4-digit code + 8 + 0 + 2 + new code twice
- Example 1234 8 02 9999 9999
Add User Codes
- Press 4-digit master code + 8 + (two digit user number 03-30) + new code
- Example to add an additional code : 1234 8 03 8888
Deleting user code
- Press 4-digit master code + 8 + (two digit user number 03-30) + # + 0
- Example to remove an additional code : 1234 8 03 # 0
Bypassing Zones
When arming, arms everything but zone(s) bypassed. The bypass or system light will stay on. To arm system without motions if you are leaving, bypassing will be required
- Press 4-digit code + 6 + (two digit zone number) + * then arm the system
- Example to bypass zone 3 : 1234 6 03 * then arm the system
Chime Mode
When chime mode is enabled, the opening of any door or window will cause a chime noise at the keypads
- Press 4-digit code + 9 to activate / deactivate.
Duress Code
An alternate code that disarms the system but also sends a silent signal to the central station.